spacer
Afinia 3D Printer Badging Class

Event Type: c3:Creative Computer Commons
Age Group(s): Adults, Teen, Tween
Date: 4/25/2017
Start Time: 3:30 PM
End Time: 5:30 PM
Description:
 In this class, you will learn all the steps required to run the Afinia 3D Printer using sample 3D Models provided in the class. Three 3D printers will be available during this session, so be prepared to partner up!

Additional Notes:
- Bring your library card to get badged for using the 3D Printer during Make II Open Hours.
- Children 9-11 must be accompanied by an adult. Children under 9 may not be in the Makerspace.
- Because of the short printing time, we cannot accommodate custom 3D models during this session.
Library: Library21c -1175 Chapel Hills Drive    Map it
Location: Make II (Messy Maker Space)
Registration Ends: 4/24/2017 at 12:00 AM
Presenter: Daniel Perez
Status: We're sorry. This event is currently full.


We're sorry. This event is currently full.